Edge-Core ES3510MA - Page 95

C HAPTER 4 | Basic Management Tasks
Managing System Files
– 95 –
CLI REFERENCES
◆ "copy" on page 512
PARAMETERS
The following parameters are displayed:
◆ Copy Type – The firmware copy operation includes these options:
■
FTP Upgrade – Copies a file from an FTP server to the switch.
■
FTP Download – Copies a file from the switch to an FTP server.
■
TFTP Upgrade – Copies a file from a TFTP server to the switch.
■
TFTP Download – Copies a file from the switch to a TFTP server.
■
HTTP Upgrade – Copies a file from a management station to the
switch.
■
HTTP Download – Copies a file from the switch to a management
station
◆ FTP/TFTP Server IP Address – The IP address of an FTP/TFTP server.
◆ User Name – The user name for FTP server access.
◆ Password – The password for FTP server access.
◆ File Type – Specify Operation Code to copy firmware.
◆ File Name –
The file name should not contain slashes (\ or /), the
leading letter of the file name should not be a period (.), and the
maximum length for file names is 31 characters for files on the switch.
(Valid characters: A-Z, a-z, 0-9, “.”, “-”, “_”)
N OTE : Up to two copies of the system software (i.e., the runtime firmware)
can be stored in the file directory on the switch.
N OTE : The maximum number of user-defined configuration files is limited
only by available flash memory space.
N OTE : The file “ Factory_Default_Config.cfg ” can be copied to a TFTP server
or management station, but cannot be used as the destination file name on
the switch.
WEB INTERFACE
To copy firmware files:
1. Click System, then File.
2. Select Copy from the Action list.