112
HemoSphere Advanced Monitor 8 Data Export and Connectivity Settings
1 Touch the value side of the Interval button and select the frequency of the data to download. The
shorter the frequency, the greater the amount of data. Options are:
• 20 seconds (default)
• 1 minute
• 5 minutes
2 Touch the Start Download button.
Case Report.
To generate a report of key parameters:
1
Touch the Case Report button.
2 Select desired parameters from the case report popup menu. A maximum of three parameters can
be selected.
3 Check De-Identify to exclude patient demographic data.
4 Touch the enter icon to export PDF.
GDT Report. To generate a report of GDT tracking sessions:
1
Touch the GDT Report button.
2 Select desired GDT tracking session(s) from the GDT Report popup menu. Use the scroll buttons
to select older tracking sessions.
3 Check De-Identify to exclude patient demographic data.
4 Touch the enter icon to export PDF.
NOTE Do not disconnect the USB device until the “Download complete” message appears.
If a message appears stating that the USB device is out of space, insert a different USB
device and restart the download.
All monitored patient data may be cleared by the user. Touch the Clear All button and confirm to clear.
8.2 Clear Data and Settings
The Clear Data and Settings screen allows the user to restore the factory defaults. For more information
on factory defaults, see below.
8.2.1 Restore Factory Defaults
When the defaults are restored, the HemoSphere advanced monitor stops all functions and restores the
system to a factory default state.
CAUTION Restore Factory Defaults replaces all settings with factory defaults. Any settings
changes or customizations will be permanently lost. Do not restore defaults while
monitoring a patient.
Status = Released Printed Date: 2018-01-16 Released Date: 2017-09-14
To Next Page
Loading...