Section 12 — The MIDI Connection
ENSONIQ KT Musician’s Manual 15
Using General MIDI in the Real World
Computer (with MIDI Interface) connected to KT-76 Keyboard
MIDI In
Internal card,
parallel port,
modem, or
printer port
MIDI Out
External MIDI Interface
(if applicable)
Using KT General MIDI Sounds with an External GM Sequencer
Connecting the KT keyboard to a computer (or other General MIDI sequencer)
1. Power down all electronic devices before making any connections.
2. Using a MIDI Cable, connect the MIDI In jack of the KT to the MIDI Out jack of the
computer/hardware sequencer/sequence player.
Note: Many computers do not have a MIDI jack built into them, and require an
additional MIDI Interface connector between the computer and the KT.
3. Make sure the proper amplification is connected to the KT, and power on the computer, the
KT keyboard, and the amplification system (in that order).
Tip: Headphones connected to the Phones jack of the KT will work fine in General
MIDI mode, and allow you to work late hours without disturbing others.
To Next Page
Loading...
Need help?
General
