Section 13 — Storage
4 ENSONIQ KT Musician’s Manual
SEQUENCES
Saving Sequencer Data to a PCMCIA Memory Card
You can save the contents of the KT sequencer memory to a PCMCIA (or an MC-512) RAM card.
To Copy sequencer memory between Internal and Card memory:
1. Press the {EDIT_SEQ/PRESET} button.
2. Press the upper {9} button. The display shows:
Press ENTER to Store Seq Data
3. Press {ENTER}. The display now lets you choose which type of storage to use.
4. Use the {VALUE} buttons to select “Storage Type=MEMORY CARD,” as shown below:
Storage Type = MEMORY CARD
5. Press {ENTER}. The display now offers four choices:
Operation = COPY i:INT TO a:CARD
This command copies the entire contents of the internal (i:INT)
sequencer bank (0-9) to the a:CARD location. Use this when
you want to save, or “back up” your sequences and songs to
the card.
Operation = COPY i:INT TO b:CARD
This command copies the entire contents of the internal (i:INT)
sequencer bank (0-9) to the b:CARD location. Use this when
you want to save, or “back up” your sequences and songs to
the card.
Operation = COPY a:CARD TO i:INT
This command copies the entire contents of the a:CARD
sequence bank to the internal (i:INT) memory. Use this when
you want to reload data previously saved to the card.
Operation = COPY b:CARD TO i:INT
This command copies the entire contents of the b:CARD
sequence bank to the internal (i:INT) memory. Use this when
you want to reload data previously saved to the card.
6. Once you have selected the operation you want from the four options above, press {ENTER}.
7. The copy function is almost instantaneous. The display will read “Command Successful”
after the sequencer data has been copied.
About Sequence Memory
The a:CARD sequencer data bank is formatted to exactly the same size as the i:INT sequencer
bank, and should be used for portable back-up of the i:INT bank, and as a transfer area. The
b:CARD sequencer bank is formatted to use the remaining card space, and is much larger than the
a:CARD and i:INT sequencer banks.
As a result, it is possible that an attempt to load all sequence data from the b:CARD bank into the
i:INT bank will result in the message “Sorry! Seq data too big to save.” Since sequencer data
stored to a PCMCIA RAM card can be played directly from the card, this should not be a
problem — this is simply a limitation of the storage medium.
Data in the b:CARD sequencer bank can be backed-up via MIDI System Exclusive to any device
that can record Sys Ex data (such as an ASR-10, TS-10, or TS-12).
To Next Page
Loading...
Need help?
General
