FLIR identiFINDER R300 - Spectrum Information Around the Chart; Acquiring Spectrum Data

FLIR Detection 6. FLIR identiFINDER R300 Menu Reference
Star
t Coordinate
t Coordinate
t Coordinate
of Horizontal Axis
of Horizontal Axis
of Horizontal Axis
End
Coordinate of
Horizontal Axis
Curr
ent Dose Rate
ent Dose Rate
ent Dose Rate
(Independent of Spectrum)
(Independent of Spectrum)
(Independent of Spectrum)
Char
t
S
caling of
Vertical Axis
Horizontal
Scale
(Zoom)
D
ead Time
A
cquisition Duration
G
amma Counts
Neutr
on Counts
(Available only for variants
equipped with a neutron
detector.)
Figure 109. Spectrum information around the chart
Settings and Commands
Skip
Cycle the list of commands (see 2.2.1, p. 35).
Press I to exit to the superior screen.
Start ⇋ Stop
Start or stop the acquisition of data for the spectrum. The current status is shown in the cen-
ter of the chart (Figure 110, p. 107), which updates live with the acquired data.
R
eal/Live Time Indicator
A
cquisition Duration
A
cquisition Status
Figure 110. Acquiring spectrum data
You cannot start the acquisition if the duration you preset (see 6.8, p. 121) for acquisition
has ended. This is indicated by a remaining acquisition duration (Figure 111, p. 108) of
0. If you try to start nevertheless, your FLIR identiFINDER R300 beeps.
identiFINDER
®
R300/en/2014.4(13623)/Feb2015 107