FLIR identiFINDER R300 - Spectrum with Cursor at Local Peak

FLIR Detection 6. FLIR identiFINDER R300 Menu Reference
The vertical scaling is adjusted to make best use of the available screen height. If you
zoom in (see below), this may cause vertical rescaling if you move the cursor between
sections with high peaks or noise.
Star
t Coordinate
t Coordinate
t Coordinate
of Horizontal Axis
of Horizontal Axis
of Horizontal Axis
End
Coordinate of
Horizontal Axis
S
caling of
Vertical Axis
Horizontal
Scale
(Zoom)
V
alues at Cursor Position
Values at Cursor PositionV
Cursor
Line
Line
Line
Cursor
Decoration
Decoration
Decoration
Figure 112. Spectrum with cursor at local peak
¶ Cursor Left
Move the cursor to the left. If you pass the left edge, the cursor wraps around to the right
edge.
Cursor Right ·
Move the cursor to the right. If you pass the right edge, the cursor wraps around to the left
edge.
Region of Interest (ROI)
You can mark a part of a spectrum for closer inspection. The region of interest is deined by
its left and right boundaries which you can set with the cursor (Figure 113, p. 110).
Mark Channel
Deine a boundary of the ROI at the current cursor position. Up to two boundaries are possi-
ble.
It does not matter which boundary of the ROI you mark irst.
1. If this is the irst marker you set, it will be decorated with diamonds (Figure 114, p. 110).
2. If this is the second marker you set, both markers will be decorated with triangles point-
ing into the deined ROI (Figure 115, p. 111).
3. If you try to set a third marker, the old marker closest to the current position will be
removed before setting the new marker.
identiFINDER
®
R300/en/2014.4(13623)/Feb2015 109