FLIR identiFINDER R300 - Choosing from a Menu: Initial State Without Chosen Item; Choosing from Menus; Skipping Commands for Value Editing; Using Command Lists

FLIR Detection 2. Operating the FLIR identiFINDER R300
2.2.1 Using Command Lists
Most features of the FLIR identiFINDER R300 offer more commands than you could immediately
reach with the FLIR identiFINDER R300’s limited number of keys.
In these cases the special command
Skip is permanently mapped to L and you can use it to cycle
the available commands. If you reach the end of the list,
L cycles to the start of the list.
For example, the commands to edit values are
+ , - , Left , Right , Accept , and Cancel (2.2.3,
p. 37). You can swap these commands with
Skip (Figure 12, p. 35).
+
-
Right
Left
Cancel
Accept
Skip
L
R
Figure 12. Skipping commands for value editing
2.2.2 Choosing from Menus
Often you have to choose an operation from a menu like, for example, the “More Options” menu
shown in Figure 13, p. 35.
Menu
Items
Key
Descriptions
Figure 13. Choosing from a menu: Initial state without chosen item
identiFINDER
®
R300/en/2014.4(13623)/Feb2015 35