4.4. Automated Mode FLIR Detection
Figure 97. Countdown announcing the start of a scheduled measurement
Automatic identiication measurements override other activities except alarms (see 5, p. 97). Au-
tomatic measurements are blocked during:
• Background measurements in Finder Mode (see 4.2, p. 88)
• A running self test (see 6.19, p. 134)
During these conditions, the countdown continues, but “Blocked” is shown instead of the count-
down timer. Should the condition end before the scheduled time, the measurement starts. Other-
wise, the measurement is omitted and a new attempt is made after the regular interval.
During the measurement, basic radiation data and a small spectrum with logarithmic scaling are
shown (Figure 98, p. 94).
Figure 98. Automated measurement
94 identiFINDER
®
R300/en/2014.4(13623)/Feb2015
To Next Page
Loading...
