10.1. Pairing the FLIR identiFINDER R300 to a Satellite Phone FLIR Detection
5. If the FLIR identiFINDER R300 has not yet been paired with any Bluetooth device, it will be-
gin the search immediately so continue to the next step. If the FLIR identiFINDER R300 has
previously been paired with another device, then the Bluetooth device selection screen will
appear (Figure 226, p. 224). Select
Change device then select Search from the next screen
(Figure 227, p. 224) to initiate a search for discoverable Bluetooth devices.
Figure 226. Select ”Change Device” if an unwanted device is paired
Figure 227. ”Prepare your Bluetooth devices…” appears after selecting ”Change device”
6. Wait a few moments while the FLIR identiFINDER R300 searches for Bluetooth devices sup-
porting the required protocol (Figure 228, p. 224).
Figure 228. Searching for Bluetooth devices
224 identiFINDER
®
R300/en/2014.4(13623)/Feb2015
To Next Page
Loading...
