FLIR identiFINDER R300 - Sending Results to a Remote Server; Identi Ication Results

FLIR Detection 3. Field Operating Guide
3.6 Sending Results to a Remote Server
This item is available for FLIR identiFINDER R300 variants with Bluetooth (see A.1, p. 237).
You can transfer identiication results or spectra to a remote server for further processing or anal-
ysis. An ANSI N42.42 ile (p. 269) containing the data is sent from the FLIR identiFINDER R300 to a
cell phone via short range Bluetooth radio and from the phone to the remote server via the Internet.
The connection requires some initial setup on the FLIR identiFINDER R300 and on the mobile
phone, please refer to section 9, p. 219 for details.
Ô
To send identication result records to a remote server…
These instructions assume that your FLIR identiFINDER R300 and your cell phone are
correctly prepared. Consult section 9, p. 219 or your IT administrator for help.
1. While the identiication results (for example of section 3.4, p. 75, Figure 72, p. 76) are dis-
played, press
Skip to reveal the command Send (Figure 78, p. 81).
Figure 78. Identiication results
2. Initiate the data transfer with Send .
A summary of the record is shown (Figure 79, p. 82).
3. Start the data transfer with
Send .
During the transfer of data you will be kept posted about the progress of the transmission
steps (Figure 80, p. 82).
If this is the irst time you are sending data since switching on the FLIR identiFINDER R300, you
have to pair it with your Bluetooth phone. Please refer to section 6.23.3, p. 144 for the complete
details.
identiFINDER
®
R300/en/2014.4(13623)/Feb2015 81