2.2. The FLIR identiFINDER R300 Keys FLIR Detection
Figure 25. Changing Numerical Values: Changing the selected digit
You increase the selected digit with + and decrease it with - . If you increase the selected digit
above 9 or decrease it below 0, the surrounding digits are changed appropriately.
If you want to change the number in larger or smaller increments, you can select another digit to
be immediateley affected by the
+ and - commands. Press Skip until you see the commands
Left or Right , and then use them to select the digit you want to change (Figure 26, p. 42).
Figure 26. Changing Numerical Values: Selecting digits
To get the commands for editing back, press Skip until + and - reappear.
After you inished editing the number, press
Skip until you see the Accept command, then press
R .
42 identiFINDER
®
R300/en/2014.4(13623)/Feb2015
To Next Page
Loading...
