FLIR identiFINDER R300 - Clock Settings; Setting Date and Time While GPS Clock Is Not Available

FLIR Detection 6. FLIR identiFINDER R300 Menu Reference
Normal
Commands are mapped to the
L and
R keys as shown in this manual.
Swapped
Commands mapped to the L and R keys are exchanged.
Down , Select
Choose and select menu items, see 2.2.2, p. 35 for details.
+ , - , Accept , Cancel
Edit values, see 2.2.3, p. 37 for details.
Exit
Return to the superior menu.
6.10 Clock Settings
Options Menu (p. 103) ä More Options (p. 103) ä Advanced Options (p. 104) ä General Options (p. 104) ä Clock Settings
Settings (p. 180) ä GPS and Clock (p. 186) ä Clock (p. 187)
You can check and change the settings of the FLIR identiFINDER R300’s clock in this screen (Fig-
ure 131, p. 125).
If the GPS receiver is switched on (see 6.11, p. 127), the received time sets the clock of the FLIR
identiFINDER R300 and the only setting you have to specify is your time zone.
If the clock setting seems unreasonable when switching on the FLIR identiFINDER R300 (see
2.5, p. 62), for example after the batteries were completely empty for a while, this screen will
show up and you will be asked to enter the correct date, time, and time zone settings.
GPS
Status
E
ditable Only While
GPS is Off
Figure 131. Setting date and time while GPS clock is not available.
identiFINDER
®
R300/en/2014.4(13623)/Feb2015 125