FLIR identiFINDER R300 - Low Power Conditions; Shutting down the FLIR Identifinder R300 During an Alarm; Battery Almost Empty; Schematic Timing of Triple Beeps Indicating Low Power Conditions

FLIR Detection 2. Operating the FLIR identiFINDER R300
Figure 58. Shutting down the FLIR identiFINDER R300 during an alarm
2.7 Low Power Conditions
When the battery runs out of power, an appropriate warning will be displayed (Figure 59, p. 65) ac-
companied by a characteristic sound (Figure 60, p. 65). The green status LED lashes with a higher
frequency (Figure 9, p. 31).
Figure 59. Battery almost empty.
Low Battery
30 s
Empty Battery
30 s
15 s
10 s
Figure 60. Schematic timing of triple beeps indicating low power conditions.
You can Shut Down with R or Continue using the FLIR identiFINDER R300 with L until the bat-
tery is completely empty, however, the only remaining operation is the dose rate mode (Figure 61,
p. 66 and 4.1, p. 86).
identiFINDER
®
R300/en/2014.4(13623)/Feb2015 65