FLIR identiFINDER R300 - Get Spectra; A.7.3 Get Spectra

A.7. SPP Commands and Updates FLIR Detection
Dose units (Lines 12 and 13)
DoseWarningThres and DoseAlarmThres use dose units. The possible scaled rem units
are ”rem” , ”mrem” , ”µrem” , and ”nrem” . The possible scaled Sievert units are ”Sv” ,
”mSv” , ”µSv” , and ”nSv” .
Dose rate units (Lines 6, 10 and 11):
DoseRate , DoseRateWarningThres , and DoseRateAlarmThres use dose rate units. The
possible scaled rem per hour units are ”rem/h” , ”mrem/h” , ”µrem/h” , and ”nrem/h”
. The possible scaled Sieverts per hour units are ”Sv/h” , ”mSv/h” , ”µSv/h” , and
”nSv/h” .
Operating Mode (Line 9):
OperatingMode indicates the current mode the FLIR identiFINDER R300 is operating in. Pos-
sible values include:
”DoseRate” , ”Finder” , ”Identify” , or ”Other” .
Neutron Information (Lines 14, 15, 26, 27, and 29):
NeutronRateWarningThres , NeutronRateAlarmThres , NeutronCountRateWarning , Neu-
tronCountRateAlarm
, and SigmaNeutronAlarm are only available on instruments that con-
tain an He-3 tube.
Sigma Alarms (Lines 28 and 29):
Sigma alarms are currently available only on R300 products.
A.7.3 Get Spectra
The ”GetSpectra” information can be queried through the command speciied below or is automat-
ically transmitted upon selection of ”send” on the user interface of the device.
Listing A.8. GetSpectra Command
1 < ? xm l v e r s i o n = ” 1. 0 ” e n c o d i n g = ” utf -8 ” ? >
2 < C o m m a n d n a m e = ” G e t S p e c t r a ” >
3 < A r g u m e n t nam e = ” N u m b e r ” v a l u e = ”(SpectrumNumber)” / >
4 < / C o m m a n d >\0
Line3: Spectrum Number
If the GetSpectra command has an Argument element then it must contain a name attribute
with a value of ”Number” and a value attribute with a numerical value specifying the record
number of the spectrum to send.
Omit the Argument element to retrieve highest spectrum number.
Listing A.9. GetSpectra Update
1 < ? xm l v e r s i o n = ” 1. 0 ” e n c o d i n g = ” utf -8 ” ? >
252 identiFINDER
®
R300/en/2014.4(13623)/Feb2015