FLIR identiFINDER R300 - Gamma Alarms

5.1. Gamma Alarms FLIR Detection
Settings and Commands
Mute
Switch off the beeper and vibrator for the current alarm. The next alarm, if any, reactivates
sound and vibration.
Acknowledge
Acknowledge the alarm.
The beeper and the vibrator are switched off (see “Mute” above) and the screen returns to the
content displayed before the alarm was raised (Figure 100, p. 98). The alarm details, however,
will alternate with the standard information in the title bar until the radiation drops below
the alarm threshold.
Alarm
State Info
State Info
State Info
Alternates with
Alternates with
Alternates with
the Normal Title
the Normal Title
the Normal Title
Figure 100. Dose rate display with alarm indication
5.1 Gamma Alarms
The FLIR identiFINDER R300 continuously compares the detected gamma radiation against thresh-
olds you can specify for
• dose warning and dose alarm (see 6.33, p. 161)
• dose rate warning and dose rate alarm (see 6.34, p. 162).
When a threshold is exceeded, an appropriate warning or alarm is raised and reported visually
(Figure 101, p. 99 and Figure 102, p. 99). The appropriate behavior of the annunciators is detailed
in Figure 103, p. 100.
98 identiFINDER
®
R300/en/2014.4(13623)/Feb2015