FLIR Detection 2. Operating the FLIR identiFINDER R300
Figure 31. Editing Text: About to delete the selected character “h”.
The characters from the selected one to the end of the text will be moved towards the beginning to
ill the gap (Figure 32, p. 45).
Figure 32. Editing Text: After deleting a character, the next character is selected.
To insert a character before the currently selected character, use Insert . The existing characters,
including the selected one, are pushed one position towards the end of the text (Figure 33, p. 46).
After you inished editing the text, press
Skip until you see the Accept command and press R
(Figure 34, p. 46).
Spaces at the start or end of the text, if any, are removed from your entry.
identiFINDER
®
R300/en/2014.4(13623)/Feb2015 45
To Next Page
Loading...
