6.23. Bluetooth FLIR Detection
6.23.3 Bluetooth Periphery
This item is available for FLIR identiFINDER R300 variants with Bluetooth (see A.1, p. 237).
Options Menu (p. 103) ä More Options (p. 103) ä Advanced Options (p. 104) ä Connectivity Options (p. 104) ä Bluetooth Periphery
This command (Figure 154, p. 144) shows the Bluetooth device your FLIR identiFINDER R300 is
currently paired with, if any, and lets you search the vicinity for other suitable Bluetooth devices
supporting dial-up networking (9, p. 219).
Figure 154. Bluetooth Periphery
If SPP Enabled is displayed, then you must irst disable the Bluetooth SPP Mode (6.23.2,
p. 142) before using Bluetooth Periphery Mode.
Figure 155. SPP Enabled
If your FLIR identiFINDER R300 is not currently paired with any Bluetooth device, the
Change Device command (see below) is executed irst.
144 identiFINDER
®
R300/en/2014.4(13623)/Feb2015