FLIR identiFINDER R300 - Switching off; Shutting down the FLIR Identifinder R300

3.7. Switching Off FLIR Detection
3.7 Switching Off
After you are done with all your measurements, you should shut down the FLIR identiFINDER R300.
The details on shutting down are given in section 2.6, p. 64, the recommended procedure follows:
Ô
To shut down the FLIR identiFINDER R300…
1. Press and hold I .
After a couple of seconds, the shut down screen will be displayed (Figure 84, p. 84).
Figure 84. Shutting down the FLIR identiFINDER R300
2. Press L to conirm the shut down command.
Store your FLIR identiFINDER R300 in its case while not in use.
84 identiFINDER
®
R300/en/2014.4(13623)/Feb2015