FLIR identiFINDER R300 - FLIR identiFINDER R300 Startup and Shutdown

2.5. Starting Up the FLIR identiFINDER R300 FLIR Detection
2.5 Starting Up the FLIR identiFINDER R300
Ô To start up the FLIR identiFINDER R300…
1. Ensure that the instrument is clean and free of visible damages.
2. Ensure that the battery is charged or connect the instrument to an external power source
(see 11.2, p. 230)
3. Press and hold
I for a moment.
The red LED lashes.
If your variant is equipped with a neutron detector, the blue LED lashes as well.
4. Release the key.
Wait a moment while the FLIR identiFINDER R300
• Identiies itself (Figure 53, p. 62),
Figure 53. Powering up the FLIR identiFINDER R300: Product identiication
• goes through start-up procedures (Figure 54, p. 63),
• initializes the software (Figure 55, p. 63).
If the time of the FLIR identiFINDER R300’s internal clock is unreasonable, most proba-
bly caused by the battery being empty for some weeks, you will be asked to set the clock
(see 6.10, p. 125).
5. The FLIR identiFINDER R300 switches to the dose rate display (Figure 56, p. 63) and is ready
for operation.
62 identiFINDER
®
R300/en/2014.4(13623)/Feb2015