FLIR identiFINDER R300 - Finder Mode: Initial Background Measurement; Finder Mode: Continuous Measurement

FLIR Detection 4. FLIR identiFINDER R300 Modes
Measuring
Duration
C
urrent Count Rate
Figure 89. Finder mode: Initial background measurement
C
ount Rate History
B
eep Threshold
eep Threshold
eep Threshold
Count
Rate Exceeded the
Rate Exceeded the
Rate Exceeded the
Beep Threshold
Beep Threshold
Beep Threshold
C
urrent Count Rate
Curr
ent Dose Rate
ent Dose Rate
ent Dose Rate
C
urrent Neutron Rate
Available only for variants
equipped with a neutron detector.
Figure 90. Finder mode: Continuous measurement
The vertical scaling of the chart is adjusted continuously to make best use of the available screen
height. A dashed line above the chart indicates the adjustable (see 6.30, p. 157) threshold for audi-
ble feed back. If the count rate rises above this level, you get notiied by the red LED, the vibrator,
and the beeper. The sound frequency is proportional to the count rate, that is, the closer the instru-
ment gets to the source the higher the tone.
You can mute the sound by pressing I for a moment. Muting remains in effect until you
leave and re-enter the Finder mode and the background measurement is repeated.
Settings and Commands
Dose
Switch to Dose Rate mode (see 4.1, p. 86).
identiFINDER
®
R300/en/2014.4(13623)/Feb2015 89