FLIR identiFINDER R300 - Plugging and Unplugging the Cable; Do Not Bend the Cable or the Plug

FLIR Detection 7. Connecting the FLIR identiFINDER R300 to a Local Computer
Always grab the plug at the strain relief and slide it straight into or out of the receptacle (Figure 181,
p. 169).
Figure 181. Plugging and unplugging the cable
Do not pull at the cable behind the connector and do not bend it when removing it from the FLIR
identiFINDER R300 (Figure 182, p. 169).
Figure 182. Do not bend the cable or the plug!
identiFINDER
®
R300/en/2014.4(13623)/Feb2015 169