FLIR identiFINDER R300 - Bulk Download (Web Page)

FLIR Detection 8. Using the FLIR identiFINDER R300 Web Server
If the settings ile contains data for settings not supported on your FLIR
identiFINDER R300, the setting will be accepted but is obviously meaningless.
You will be informed about success or failure after the upload.
Reset Factory Settings
Discard all changes you made to any of the FLIR identiFINDER R300’s settings and reestablish
the settings made at the factory.
The password (see 2.2.7, p. 46), if any, is reset to the factory setting as well.
8.10 Bulk Download (Web Page)
Data (p. 180) ä Bulk Download
This web page lets you download all or a selection of the data saved in your FLIR
identiFINDER R300’s database to your computer (Figure 209, p. 198). The records matching cer-
tain criteria will be wrapped into a
*.zip archive and downloaded.
Date Selection
Limit the records to be downloaded by their saving date (in ISO 8601 notation).
A pop-up calendar helps you to enter the dates.
Several buttons are available to enter common date combinations ( Today , Last Week ,
etc.).
Start Date […]
The date of the oldest record to be downloaded. Leave this ield empty to get the oldest
record available in the database of the FLIR identiFINDER R300.
End Date […]
The date of the youngest record to be downloaded. Leave this ield empty to get the
youngest record available in the database of the FLIR identiFINDER R300.
Data Types
Limit the records to be downloaded by their type.
The actual collection of available types depends on the variant of your FLIR
identiFINDER R300.
4
Identications
Include identiication results in the archive.
4
Spectra
Include spectra in the archive.
4
…
Include other data types in the archive.
identiFINDER
®
R300/en/2014.4(13623)/Feb2015 197