2.8. Resetting the FLIR identiFINDER R300 FLIR Detection
Figure 61. Low Power Dose Rate Mode
If the battery is completely empty, another message (Figure 62, p. 66) will appear accompanied by
a characteristic sound (Figure 60, p. 65).
Figure 62. Battery is empty.
You should switch off the instrument.
Please connect the FLIR identiFINDER R300 to an external power source (see 11.1, p. 229).
2.8 Resetting the FLIR identiFINDER R300
The FLIR identiFINDER R300 can be reset by performing a normal shut down–start up cycle.
All your custom settings remain unchanged by this procedure. To revert the instrument to
the factory defaults, use
Reset Factory Settings (6.15, p. 132).
66 identiFINDER
®
R300/en/2014.4(13623)/Feb2015
To Next Page
Loading...
