7.2. The FLIR identiFINDER R300 as a Mass Storage Device FLIR Detection
7.2 The FLIR identiFINDER R300 as a Mass Storage Device
Computers supporting the connection of USB devices usually have a driver for devices identifying
themselves as mass storage, for example USB sticks or USB hard disks. The FLIR identiFINDER R300
supports the same standard.
You can use this mode of operation, for example, to install the drivers for the web interface access
(7.3, p. 171).
Ô
To mount the FLIR identiFINDER R300 as USB mass storage…
1. Switch the FLIR identiFINDER R300 to mass storage mode (see
Mass Storage , 6.25, p. 150).
2. Connect the FLIR identiFINDER R300 to the computer with the included cable.
The mass storage device shows up on your computer after a few moments (Figure 183,
p. 170).
The FLIR identiFINDER R300 hard drive is write protected, that is, you cannot modify
or add any data.
Figure 183. FLIR identiFINDER R300 mounted as mass storage device on a computer running Microsoft
Windows 7
Ô To unmount the FLIR identiFINDER R300 as USB mass storage…
1. Follow the standard procedure for unmounting mass storage devices as recommended by
your operating system. Please refer to the manual or help system that came with your oper-
ating system for details.
2. Unplug the connection cable.
3. Press
Exit on the FLIR identiFINDER R300 to return from USB mass storage mode to normal
operation (see 6.25, p. 150).
170 identiFINDER
®
R300/en/2014.4(13623)/Feb2015
To Next Page
Loading...
