FLIR identiFINDER R300 - Clock Settings: Selecting the Time Zone

6.10. Clock Settings FLIR Detection
If GPS date and time information become available while you edit the date or time, editing
will be cancelled and the GPS clock is used.
Settings and Commands
Time Zone
Select your time zone from the list built into the FLIR identiFINDER R300. Time zones are
speciied as offset from UTC/GMT (Figures 132–133, p. 126–126).
Periods for daylight savings time, however, might be different for the same offset from UTC in
various regions. To have the FLIR identiFINDER R300 consider the correct daylight savings
time for your time zone, make sure to check the region info when selecting the offset.
GPS
Status
T
ime Zone Offset
T
ime Zone Region
GPS
Clock is Used to
Set Date and Time
Figure 132. Clock Settings: Selecting the time zone
GPS
Status
T
ime Zone Offset
T
ime Zone Region
GPS
Clock is Used to
Set Date and Time
Figure 133. Clock Settings: Selecting the time zone
126 identiFINDER
®
R300/en/2014.4(13623)/Feb2015