4.3. Identication Mode FLIR Detection
Identify
Switch to Identiication mode (see 4.3, p. 90).
Options
Inspect and change options (see 6, p. 103).
4.3 Identication Mode
You can switch the FLIR identiFINDER R300 to Identiication Mode to perform the actions neces-
sary to identify the nuclides gamma radiation is originating from.
The instrument acquires a gamma spectrum for a duration you can specify (6.4, p. 116) and shows
the progress and some parameters of the measurement (Figure 91, p. 90).
The spectrum acquired here overwrites the current contents of the spectrum viewer (6.2,
p. 106). Data acquisition in the spectrum viewer, if any, is stopped.
Figure 91. Identiication Mode: Progress display during time limited data acquisition
The FLIR identiFINDER R300 achieves better identiication results if the count rate is within a cer-
tain range shown in the center of in the indicator. While the current count rate is outside the desired
range, advices are shown so you can shorten (Figure 92, p. 91) or lengthen (Figure 93, p. 91) the
distance between the instrument and the radiation source.
If the acquisition is limited not by the time, but the number of counts (6.4, p. 116), the display looks
slightly different (Figure 94, p. 92).
You should try to move the instrument into a good position although the advice on moving
the instrument in a position for best identiication is not shown in this mode to make room
for the number of counts relative to the required minimum.
90 identiFINDER
®
R300/en/2014.4(13623)/Feb2015