FLIR identiFINDER R300 - Entering a Password to Access the Option Menus

FLIR Detection 2. Operating the FLIR identiFINDER R300
Figure 35. Entering a password to access the option menus.
For better protection against unwanted changes of the instrument characteristics, you should
change the password to something else (6.12, p. 128).
If you don’t need protection but want faster access to the menus, you can remove the password
(6.13, p. 129).
Settings and Commands
Skip
Cycle the list of commands (see 2.2.1, p. 35).
L , M , R
Enter the password by seven presses in the correct sequence.
To cancel the password entry press I for a moment.
After the seventh entry, the key labels change (Figure 36, p. 48).
Accept
Conirm your password entry and have the instrument check your entry for correctness.
After you entered the correct password, you don’t have to enter it again until you switch
off the instrument.
If you enter a wrong password, you will be informed (Figure 37, p. 48). After you conirm the
message with
OK , the instrument will return to the mode it was in before asking for the
password.
Cancel
Cancel the password entry and return without proceeding to the protected options and com-
mands.
identiFINDER
®
R300/en/2014.4(13623)/Feb2015 47