FLIR identiFINDER R300 - Editing Text: after Inserting Space before Doe for an Additional Character; Editing Text: Done; Entering the Password

2.2. The FLIR identiFINDER R300 Keys FLIR Detection
S
elected Entry Field
S
elected Character
Inser
t Character
R
evealMoreCommands
evealMoreCommands
evealMoreCommands
Figure 33. Editing Text: After inserting space before “ Doe” for an additional character.
Figure 34. Editing Text: Done.
In case you change your mind, you can Cancel editing the value with R (Reveal the command
with
Skip if necessary). The value in effect before you started editing with Select will be reestab-
lished.
Pressing
I for a moment also cancels editing.
Do not press I for too long. That would power down your FLIR identiFINDER R300.
2.2.7 Entering the Password
If your FLIR identiFINDER R300 is protected by a password, you will have to enter it before you can
access most of the options and settings menus of the instrument (Figure 35, p. 47).
If your variant comes with a factory-set password, it is
LMRLMRL .
46 identiFINDER
®
R300/en/2014.4(13623)/Feb2015