FLIR Detection 5. FLIR identiFINDER R300 Alarms
Chapter 5
FLIR identiFINDER R300 Alarms
If the FLIR identiFINDER R300 detects radiation above certain thresholds you can specify (see 6.33,
p. 161), it raises an alarm. Alarms can be reported via several annunciators:
Main Display
Details of the alarm are always displayed on-screen, no matter which other activity was dis-
played at the time the alarm condition was met (for example, Figure 101, p. 99).
The screen backlight will be switched on if it timed out (6.9, p. 122).
The alarm details remain on the screen until you dismiss them.
Status Bar
If you dismiss the alarm details, the alarm and warning information is shown in the status
bar along the display’s top edge alternating with the normal information shown there (Fig-
ure 100, p. 98).
LED LEDs (Figure 7, p. 28) lash in several patterns.
Beeper
The beeper emits various sound patterns.
Vibrator
The vibrator shakes the instrument (and adds a little sound).
You can switch the LEDs, the beeper and the vibrator on or off (see 6.32, p. 160).
All alarms are stored in the FLIR identiFINDER R300’s database, including date and time (always)
and GPS coordinates (if switched on and available, see 6.11, p. 127).
You can review saved alarms via the web interface (8.13, p. 206) or delete them (6.17, p. 133)
identiFINDER
®
R300/en/2014.4(13623)/Feb2015 97
To Next Page
Loading...
