Fujitsu M10-4 - Page 5

5.4.2 Enabling the removal of an I/O device 61
5.4.3 Releasing a chassis requiring maintenance from the physical
partition 69
5.5 Powering Off the Physical Partition Requiring Maintenance 71
5.6 Stopping the Entire System 73
5.6.1 Stopping the system with the XSCF command 73
5.6.2 Stopping the system from the operation panel 75
5.7
Saving XSCF Setting Information 75
5.8 Releasing a SPARC M10-4/M10-4S FRU from the System with the
replacefru Command 76
5.8.1 Releasing of the SPARC M10-4S chassis (possible only in a
system with a building block configuration) 76
5.8.2 Releasing of the power supply unit and fan unit of the SPARC
M10-4/M10-4S 78
5.9 Accessing an FRU 79
5.9.1 Removing the crossbar cables from the cable support 80
5.9.2 Lowering the cable support 82
5.9.3 Lowering the cable support (if it is a new model) 84
5.9.4 Removing the power cord 85
5.9.5 Removing the front cover 86
Chapter 6 Restoring the System 87
6.1 Restoring the
Chassis 87
6.1.1 Installing the power cord 87
6.1.2 Fixing the cable support 88
6.1.3 Fixing the cable support (if it is a new model) 89
6.1.4 Attaching the crossbar cables to the cable support 90
6.1.5 Installing the front cover 91
6.2 Incorporating a SPARC M10-4/M10-4S FRU into the System with the
replacefru
Command 92
6.2.1 Incorporation of the SPARC M10-4S chassis (possible only in a
system with a building block configuration) 92
Contents v