Fujitsu M10-4 - Page 6

6.2.2 Incorporation of the power supply unit and fan unit of the
SPARC M10-4/M10-4S 94
6.3 Diagnosing a Replacement FRU 96
6.3.1 Diagnosing the system board 96
6.3.2 Diagnosing the crossbar unit and crossbar cables 96
6.4 Restoring XSCF Setting Information 97
6.5 Incorporating a Chassis and I/O Device into a Physical Partition
98
6.5.1 Incorporating a chassis into a physical partition 98
6.5.2 Incorporating an I/O device 99
6.5.3 Restoring the logical domain to the pre-maintenance state 102
6.6 Returning the Mode Switch to Locked Mode 107
6.7 Powering On the Physical Partition Requiring Maintenance 107
6.8 Starting the Entire System 108
6.8.1 Starting the system
with an XSCF command 108
6.8.2 Starting the system from the operation panel 109
Chapter 7 Maintenance Flow 111
7.1 Maintenance Workflow 111
7.2 FRU Replacement Workflow 113
7.2.1 Active replacement 114
7.2.2 Inactive replacement 122
7.2.3 System-stopped replacement 130
7.3 FRU Installation Workflow 138
7.3.1 Active addition 138
7.3.2 Inactive addition 143
7.3.3 System-stopped addition
147
7.4 FRU Removal Workflow 152
7.4.1 Active removal 153
7.4.2 Inactive removal 158
7.4.3 System-stopped removal 162
Chapter 8 Maintaining the PCI Express Cards 169
8.1 Configuration of the PCI Express Cards 169
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
November 2014vi