Chapter 6: Image Acquisition
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 6-18
Operator Manual © 2008 General Electric Company. All rights reserved.
1. Press [DISCONTINUE] from the bottom of the Acquisition screen.
A message appears: “Please select a reason for discontinuing this exam.”
2. Select the option that best describes why the exam is being discontinued.
Choose “Discontinue for unspecified reason” if no other options describe the current situation.
3. Press [OK].
The message closes and the Worklist screen opens.
The status of the procedure changes to “Discontinued” on the Worklist.
If multiple procedures were selected, the discontinued status applies to all procedures that were
open when the exam was discontinued.
Press [CANCEL] to close the message and return to the Acquisition screen.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
