Appendix B: Login Administration
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) B-8
Operator Manual © 2008 General Electric Company. All rights reserved.
NOTE: Remember the following when creating user names:
– You cannot use the names “operator”, “admin”, or “administrator.” These names are reserved
for use by the system and GE Service personnel.
– User names cannot have spaces or uppercase (capital) letters. Use all lowercase letters in
the username and use underscores to separate words.
– User names cannot have special characters: ~!@#%^&*()+=[]{}\|:;’”,.<>/?
– The User name must be unique. That is, the system will not allow two people to have the
same user name.
4. Type the user’s First Name.
This text box may be left blank but it is recommended that you type a name.
NOTE: Capital letters, spaces, and punctuation are allowed in the First Name and Last Name text boxes.
5. Type the user’s Last Name.
This text box may be left blank but it is recommended that you type a name.
6. Type a Password.
NOTE: The default system does not have pre-configured standards for password format or construction;
however, your facility may have password standards that must be followed. Ask your facility’s
System Administrator about password standards and create passwords that conform to those
standards.
7. Re-type the password in the Confirm Password text box.
NOTE: The passwords must match exactly to be accepted.
8. Click [SUBMIT].
The new user is added to the table.
If the Username cannot be used or if the passwords do not match, you will receive a message that
informs you of the problem. Type the correct information and click [SUBMIT] again.
Assign Users to Groups
1. Select the checkbox under the group heading to add the user to that group.
2. Click on a selected checkbox to remove the user from the group.
NOTE: You may select or deselect groups for multiple users.
NOTE: You cannot change the group assignments for protected users.
3. Click [APPLY USER SETTINGS].
Change User Password
You cannot see user’s passwords for security reasons. In the event of a forgotten password, you may
change the password and then tell the user the new password.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
Need help?
General
