Chapter 10: Set Preferences
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 10-18
Operator Manual © 2008 General Electric Company. All rights reserved.
Image Management
Image Management preferences allow you to enable and configure the Copy Exam, Auto Tag, Auto Print,
Auto Push, and Auto Delete functions.
Figure 10-13 Preferences – Image Management
Copy Exam
Enabling the Copy Exam function allows exams to be copied between the local databases and network
hosts. It also allows exams to be copied to a CD.
There is no configuration for this function; it is either enabled (ON) or disabled (OFF).
Follow this process to enable or disable Copy Exam:
1. From the Worklist screen, press [UTILITIES].
2. Select Preferences > Image Management.
3. Press Copy Exam [ON] to enable the function.
Copy Exam [OFF] disables the function.
4. Press [CLOSE].
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
Need help?
General
