Chapter 10: Set Preferences
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 10-27
Operator Manual © 2008 General Electric Company. All rights reserved.
Figure 10-18 Pre-set Annotation editing
4. To change the order of the list, select the annotation.
5. Press the [
] or [] button to move the item up or down the list.
6. Continue with Add Pre-set Annotation
(p. 10-27), Edit Pre-set Annotation (p. 10-27), or Remove Pre-set
Annotation (p. 10-28).
7. When finished, press [SAVE] to retain your changes.
8. Press [CLOSE].
Add Pre-set Annotation
1. From the Pre-set Annotations screen, press [ADD].
2. Enter the text of the annotation.
3. Press [ADD].
Edit Pre-set Annotation
1. From the Pre-set Annotations screen, select the annotation.
2. Press [EDIT].
3. Edit the text of the annotation.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).