Chapter 4: General Information
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 4-4
Operator Manual © 2008 General Electric Company. All rights reserved.
Follow this process to login to the system.
1. Start up the system or log off the previous user.
The Login screen appears.
2. Enter your Login Name, if necessary.
3. Type in your Password.
4. Press [LOGIN].
The Worklist appears.
NOTE: If you have administrator access, a message appears: “You have both regular user and admin user
privileges. To access the admin screen, select the check box before continuing with the login,
otherwise just continue with the login.”
– To login and begin working with the unit, press [LOGON] and the Worklist appears.
– To login and access login administrator functions, select the Enter admin screen checkbox
and then press [LOGON]. The Login Administration screen appears. Refer to Appendix B:
Log-
in Administration for more information.
Invalid Password Message
Your Password must be entered correctly for you to log in. If the password you entered is not the correct
password for the entered Login Name, an error message will appear.
1. Make sure that the correct Login Name is displayed in the field. Depending on the configuration, the
Login Name may be case sensitive. That is, “aBc” is not the same Login Name as “Abc.”
2. Retype your Password carefully. Your password is case sensitive; that is, “xYz” is not the same
password as “Xyz.”
3. Press [LOGON].
Contact your technical support group or system administrator if you still are not able to login.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
Need help?
General
