Chapter 10: Set Preferences
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 10-1
Operator Manual © 2008 General Electric Company. All rights reserved.
Chapter 10: Set Preferences
Preferences allow a super-user to customize the system. This chapter explains the Preferences available
to you and how to activate or change the preferences for your facility, such as:
• Predefine X-ray procedure parameters so that any stored procedure may be retrieved from memory,
allowing you to access technique factors programmed for that type of procedure.
• Enable automatic networking and printing features.
• Customize system default annotations and image orientation.
• Create preferences for image processing.
• Save commonly used operator and physician names in your system for later recall.
Topics covered include:
Preferences are set on the Utilities screen (Figure 10-1), which is accessed by pressing the [UTILITIES]
button on the Worklist.
• System
(p. 10-2)
– Network Connections
(p. 10-2)
– Printers
(p. 10-7)
• Worklist
(p. 10-13)
– Default Query
(p. 10-13)
– Preset Names
(p. 10-15)
• Image Management
(p. 10-18)
– Copy Exam
(p. 10-18)
– Auto Tag (Quality Check)
(p. 10-19)
– Auto Print
(p. 10-19)
– Auto Send (Auto Push)
(p. 10-22)
– Auto Delete
(p. 10-23)
• Image Viewer
(p. 10-26)
– Configure Pre-set Annotations
(p. 10-26)
• DEI (Detector Exposure Index)
(p. 10-29)
• Exam
(p. 10-31)
• Image Processing
(p. 10-32)
– Build Custom Looks
(p. 10-33)
– Tissue Equalization Overview
(p. 10-37)
• Protocols
(p. 10-40)
– Backup Protocol Database to CD
(p. 10-41)
– Retrieve Protocol Database from CD
(p. 10-
42)
– Edit Protocol Database
(p. 10-42)
– Protocol Editor Copy Functions
(p. 10-50)
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
