Chapter 10: Set Preferences
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 10-3
Operator Manual © 2008 General Electric Company. All rights reserved.
Figure 10-2 Network Connections screen
Add or Edit Network Host
Adding and editing network hosts use very similar process and the same screens as shown in Figure 10-
3 and Figure 10-4. Table 10-1 and Table 10-2 describe the fields in detail.
• If editing an existing connection, select the network host and press [EDIT].
• If adding a new connection, press [ADD].
1. Complete requested information for both tabs (see Table 10-1 and Table 10-2) and press [SAVE] to
add the network host or save the changes.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
