Chapter 2: Safety and Regulatory
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 2-10
Operator Manual © 2008 General Electric Company. All rights reserved.
Product Identification
The major items in the equipment have some identification labels attached to them which provide the
following manufacturer and product information.
•Product
•Model
• Volts (V), Line Phases, Frequency (Hz), and Power (kVA, kW)
• Date of manufacture
• Serial number
• Reference
• Manufacturer
• Place of manufacture
•Certification
Table 2-3 identifies the type of compliance plates and their location on your system.
Table 2-3 System identification and compliance plates
Component Plate Type Component Plate Type
Carbon fiber fixed
table
Identification, HHS, CE,
NRTL
GE software Identification
Collimator Identification, HHS, CE,
NRTL
HV Tank Identification, HHS, CE,
NRTL
X-Ray Tube Identification, HHS, CE,
NRTL
Image Paste Patient
Barrier
Identification, HHS
CRIB Identification, HHS Ion Chamber Identification
DAP Identification, HHS Laminate fixed table Identification, HHS, CE,
NRTL
Definium 5000 System Identification, HHS, CE,
NRTL
Magic 6400 PC Identification
Digital Detector Identification Installation Dolly Identification, CE
Elevating table Identification, HHS, CE,
NRTL
X-Ray Generator Identification, HHS, CE,
NRTL
Sedecal Software Identification
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
