Chapter 10: Set Preferences
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 10-13
Operator Manual © 2008 General Electric Company. All rights reserved.
Worklist
Worklist preferences are available from the Utilities screen.
1. On the Worklist screen, press [UTILITIES].
2. Select Preferences > Worklist.
Figure 10-9 Preferences – Worklist screen
Default Query
The Worklist Default Query controls the amount of HIS/RIS information that appears on the Worklist and
allows you to enable and configure the auto-refresh function.
1. Complete or edit the Worklist Default Query screen (Figure 10-10). Table 10-6 describes the fields in
detail.
2. Press [SAVE] to change the Default Query.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
