Chapter 4: General Information
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 4-5
Operator Manual © 2008 General Electric Company. All rights reserved.
Emergency Login
Emergency Login is a HIPAA required function to allow quick access to medical systems in the event of an
emergency. Depending on the system’s configuration, this option may not be available. Refer to
Appendix B:
Login Administration to configure the Emergency Login function.
Emergency Login will allow exposures, but does not allow connection to HIS/RIS or PACS hosts.
CAUTION: The Emergency Login function should NOT be used when there is time to login normally,
when there is time to receive assistance from technical support, or if there is no emergency
situation. Your facility may track the use of this function.
1. Press [EMERGENCY LOGON].
Depending on the system’s configuration, you may be prompted to enter your name. Enter your
name and press [LOGIN].
2. The Worklist screen appears.
Log Off
1. Close, suspend, or discontinue any open exams, if necessary.
2. Close the Image Viewer, if necessary.
3. Press [LOGOFF] at the top of the Worklist or Image Management screen.
Or open the Utility screen, go to System and press [LOGOFF] (Figure 4-4).
Figure 4-4 Utilities screen logoff button
A message appears: “Do you really want to log off?”
4. Press [OK].
The Login screen appears.
[CANCEL] closes the screen and returns you to the last screen.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
