Chapter 10: Set Preferences
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 10-32
Operator Manual © 2008 General Electric Company. All rights reserved.
Image Processing
The Image Processing preferences allow you to change which look is the default for the anatomical view.
Image Processing Preferences also allow you to view the settings of default factory looks or to create up
to five (5) custom looks.
NOTE: Custom looks and the default looks mapping can be backed up by having GE Service personnel
perform a system backup. It is recommended that a system backup be performed after any change
to the default looks mapping or when custom looks are built. Ask your GE Service personnel to
perform the system backup at their next visit. GE Service personnel can restore the settings from
the backup, if necessary.
Figure 10-22 Preferences – Image Processing
Change Default Factory Looks for Exams
The Default Factory Looks screen (Figure 10-23) allows you to change the default processing setting for
all 34 representative anatomical views, and then map this change to related anatomical views. Note that
this may over-ride existing default settings.
At the initial applications setup, the radiologist chooses the default look for each anatomical view.
Application specialists assign the looks to the system.
Follow this process to change the default factory looks.
1. From the Worklist screen, press [UTILITIES].
2. Select Preferences > Image Processing.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
Need help?
General
