Chapter 5: Worklist
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 5-13
Operator Manual © 2008 General Electric Company. All rights reserved.
Figure 5-8 Delete button options
2. Press the action you want to perform.
The system performs the action and the button name changes to the selection you made. The
button will perform the selected action each time it is pressed until you change it.
NOTE: [DELETE] or [DELETE ALL] does not remove procedures from the RIS or HIS. [DELETE] or [DELETE
ALL] does not remove any exam images from the image database.
Delete a Single Procedure
1. Select the procedure to delete.
2. Press [DELETE]. If necessary, switch the button to [DELETE].
A message appears: “Are you sure that you would like to delete the selected items?”
3. Press [OK] to delete the procedures.
[CANCEL] retains the procedures and the Worklist appears.
Delete All Completed, Discontinued, and Local Procedures
1. Press [DELETE ALL]. If necessary, switch the button to [DELETE ALL].
A message appears: “All Completed, Discontinued, and locally scheduled exams will be deleted
from this list. Any suspended exams will need to be individually deleted.”
2. Press [OK] to delete the procedures.
The selected procedures are deleted and the Worklist appears.
[CANCEL] closes the message, retains the procedures, and takes you back to the Worklist.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
Need help?
General
