Chapter 5: Worklist
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 5-12
Operator Manual © 2008 General Electric Company. All rights reserved.
Select Procedures
Use the following processes to select a patient from the Worklist. This process assumes the patient
already exists on the system. If the patient is not on the Worklist, you must add the patient first. Refer to
Overview
(p. 5-15) for more information.
Select a Single Procedure
1. Close or suspend any open exams, if necessary. Refer to Chapter 6: Image Acquisition-End Exam
(p. 6-16) for more information.
The Worklist screen appears.
2. Select the procedure from the Worklist.
3. Refer to Chapter 6:
Image Acquisition to conduct the exam.
Select Multiple Procedures
You may select multiple procedures for the same patient to begin image acquisition.
NOTE: The Patient Name, Patient ID #, and Exam Date must match exactly in order to be selected.
1. Sort the Worklist by Patient Name, if necessary.
2. Press procedure.
3. Press another procedure for the same patient.
4. Continue pressing procedures until all procedures for the patient are selected.
5. Press any other procedure to deselect the procedures.
Delete Procedures
You may remove procedures from the Worklist individually or all completed, discontinued, and locally
added procedures at once.
The [DELETE] button is able to switch between individual delete or delete all.
NOTE: Deleted procedures cannot be recovered or “undeleted.”
To switch the button between “Delete” and “Delete All”:
1. Press on the small arrow on the right side of the button.
A list appears with the available actions.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
Need help?
General
