Chapter 8: Image Viewer
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 8-16
Operator Manual © 2008 General Electric Company. All rights reserved.
Figure 8-10 Editing the manual shutter
Figure 8-11 Close up of manual shutter
3. Click and drag the red corner handles to the desired shape and size.
NOTE: Any image annotations (line, Cobb, ellipse, R/L marker) that are outside of the visible image area
will be lost when the exam is closed. Make sure that annotations are within the active image area.
Manual shutters do not effect system annotations.
4. Click [MANUAL SHUTTER] to apply the adjustment.
If the image does not return to its selected size, click the Zoom buttons on the Viewer Display
panel to re-select the viewing size. Refer to Change Image Display
(p. 8-6) for more information.
Figure 8-12 Image after adjusting shutter
5. Click [MANUAL SHUTTER] again to edit.
Automatic Shutter
The Definium 5000 is able to detect collimation edges present in an x-ray radiograph. This allows the
system to provide a shuttered image on the viewer.
In the event of incorrect automatic shuttering, the image can be recovered by manually re-shuttering the
image to visualize the desired anatomy and then re-processing with the same look.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
