Chapter 7: Automatic Exposure Control (AEC)
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 7-9
Operator Manual © 2008 General Electric Company. All rights reserved.
10. Collimate the light field to encompass the detection area being used.
11. Collimate to the desired area. This ensures the detector sensing area is aligned with the patient’s
anatomy.
12. Confirm the Patient Position. Change if necessary.
13. Make the exposure.
14. If the AEC Back-up Reached message appears: Click [OK].
The message closes.
15. Select another protocol and continue the exam.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
