Chapter 10: Set Preferences
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 10-49
Operator Manual © 2008 General Electric Company. All rights reserved.
Figure 10-31 Edit Techniques screen
19. Change the technique parameters as appropriate.
20. Upon completion for each view, press [NEXT TECH] adjust techniques for the next configured patient
size.
21. When finished, press [EXAM MENU].
The Exam Menu appears.
22. Press [SAVE].
A message appears: “Changes made to the Protocol Database will be saved.”
[RESET] clears all changes to the database since the last time it was saved.
23. Press [OK].
The Preferences – Protocols screen appears.
24. Press [CLOSE].
A message appears: “Changes have been made to the Protocol Database. Would you like to save
these changes?”
25. Press [YES].
The Exam Menu screen closes and returns you to the Preferences - Protocols screen.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
