Chapter 11: Quality Assurance Process and Maintenance
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 11-12
Operator Manual © 2008 General Electric Company. All rights reserved.
Cleaning and Disinfecting
This equipment should be cleaned frequently, particularly if corroding chemicals are present. Use a cloth
moistened in warm soapy water (use mild soap) to clean the trim and nameplate of the Operator’s
Controls. Wipe with a cloth moistened in clean water.
Do not use cleaners or solvents of any kind as they may dull the finish or blur the lettering. Polish with a
pure liquid or paste wax. Other surfaces of the equipment can be cleaned using a clean cloth moistened
slightly with a good mild cleaner and polish acceptable for use on enameled metal surfaces. Before each
use, equipment surfaces that contact the patient should be cleaned with an EPA registered, low-level
disinfection or sanitizing agent.
CAUTION: In the event of equipment contacting broken skin or being used with infected or immune
compromised patients, the equipment should be cleaned using EPA cleared and EPA
registered high-level disinfecting agents.
NOTE: Be sure to follow the label instructions and pre-cautions for use, storage, and disposal of all
disinfecting agents.
NOTE: Clean the surface of the PC with a damp cloth.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
