Appendix A: Image Pasting
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) A-4
Operator Manual © 2008 General Electric Company. All rights reserved.
1. Align positioner with the receiving holes in the floor.
Figure A-5 Positioner and receiving hole
2. Push the lock lever down so that the pin goes into the hole (Figure A-6).
Figure A-6 Lock lever pushed down
3. Push the back of the lock lever down to lock (Figure A-7).
Figure A-7 Lever in locked position
4. Lock the other side.
NOTE: When the positioner is not being used, unlock one side and rotate the positioner out of the way.
This will save you time and space for storing the positioner.
5. Unlock the positioner by pressing the front of the lock lever down (so that it is horizontal, as show in
Figure A-6) and letting the lever rise up.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
