Chapter 3: System Overview
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 3-14
Operator Manual © 2008 General Electric Company. All rights reserved.
Follow this process to change the settings of a pre-programmed position.
1. On the Programs screen, press and hold the [PROGRAMS] button for 5 seconds.
Figure 3-12 Touch Screen Console – Programs button
A virtual keyboard screen appears (Figure 3-13).
Figure 3-13 Touch Screen Console – Password screen
2. Insert the password (1111).
3. Press [OK].
4. Select the Program position number to be modified and Press [MODIFY].
Figure 3-14 Programs modifying
5. Move the Arm to the desired position.
1. Reference picture of the selected position
2. Position number
3. Access to modifying the programmed position
4. Programmed position data
5. Save positioning data
6. Exit from modifying position
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
